Description

SECO 2.5mm 6deg R/H Part Off Insert

– 14 Chipbreaker -First choice for stainless steel.
– First choice for steel at medium-high feed rates.
– 15 positive cutting rake angle with sharp edge.

TGP45 – Wear-resistant Duratomic CVD-coated grade intended for parting-off of steel and stainless steel at moderate to high cutting speeds.

-The R-/L-inserts have a setting angle of 6 in order to eliminate burrs and minimize the parting-off pip left on the workpiece. To reduce pip size with N-inserts, use the smallest width possible. The correct centre height is another major factor to avoid pips (control to 0.1 mm).
-When using R-/L-inserts, the feed rate should be reduced by approximately 30%.
-Convex or concave surfaces will be avoided, when using right or left hand inserts, by reducing the feed rate.